BEST ACCESS SYSTEMS W Series Service Manual page 178

Installation Instructions for 34HW–35HW IDH Max Mortise Locks
Set screw
cap
Set screw
Spindles
Outside of door
Figure 15a Installing the knobs
Set screw
Spindles
Outside of door
Figure 15b Installing the levers
14
Completing the installation at the door
15
For both knobs and levers
Unscrew the inside spindle one (1) full turn to allow the
spindles to turn freely.
For knobs
1 From the outside of the door, insert the outside knob
and spindles assembly into the lockset.
2 Slide the inside knob onto the inside spindle and
secure it with the set screw.
3 Push the set screw cap into the set screw hole.
4 Tighten the trim mounting screws.
5 Turn the knobs to check that they operate smoothly.
For levers
1 With the handle pointing toward the door hinges,
insert the outside lever and spindles assembly into the
lock from the outside of the door.
Inside of door
2 Slide the inside lever onto the inside spindle and
secure it with the set screw.
3 Tighten the trim mounting screws.
4 Turn the levers to check that they operate smoothly.
Inside of door
BEST ACCESS SYSTEMS
Indianapolis, Indiana
Install inside and outside knobs/levers