BEST ACCESS SYSTEMS W Series Service Manual page 199

Installing the lock & through-bolt trim
12
Install lock chassis and engage
retractor in latch
From the outside of the door, insert the lock chassis
into the 2 1/8" chassis hole, routing the solenoid wire
through the notch.
Caution: Make sure that the latch tube prongs
engage the chassis frame and that the latch
tailpiece engages the retractor.
13
Install through-bolts and RQE rose
liner
1 Place the RQE rose liner on the chassis, aligning the
holes in the rose liner with the holes prepared in the
door.
Caution: Make sure that there is clearance for the
solenoid wire between the RQE rose liner and the
door.
2 Install the through-bolts through the RQE rose liner
and door in the top and bottom holes.
3 Tighten the RQE rose liner on the door with the
through-bolts.
Installation Instructions for 83KW/93KW–85KW/95KW IDH Max Cylindrical Locks Installation Instructions for 83KW/93KW–85KW/95KW IDH Max Cylindrical Locks
BEST ACCESS SYSTEMS
Indianapolis, Indiana
Retractor
Latch tube
prong
Latch
tailpiece
Latch tube
prong
Chassis frame
Notch
Inside of door
Figure 12 Installing the lock chassis and engaging the
retractor in the latch
Through-bolt
RQE wire
RQE rose liner
Solenoid wire
Figure 13 Installing the through-bolts and RQE rose liner
Chassis
RQE rose
liner
Inside of door
11