BEST ACCESS SYSTEMS W Series Service Manual page 144

Additional Service and Maintenance for IDH Max Locks
6–4
6. Loosen the screw holding the harness clamp and remove the clip.
Save the clip.
Control electronics circuit board
Reader wire harness
Lower left mounting screw
Harness clamp
Figure 6.2 Removing the harness clamp
7. Disconnect the reader wire harness from the reader circuit board.
Reinstalling the reader wire harness
1. Connect the reader wire harness to the reader circuit board.
2. Slide the harness clamp under the loosened screw. Tighten the
screw. See Figure
3. For magnetic stripe swipe and proximity card readers, peel away
the protective backing from the edge of the escutcheon gasket and
slide the gasket onto the upper escutcheon post. Press the gasket
into place on the edge of the escutcheon so the reader circuit board
is covered.
4. Connect the reader wire harness to the control electronics circuit
board. For mortise instructions, see Task E. To connect the reader
wire harness: on
Tighten the RQE rose liner on the door with the through-bolts. on
page 5–12.
5. Reinstall the outside escutcheon. For mortise instructions, see
Task F. To secure the escutcheons and complete the connections:
on page 4–20. For cylindrical instructions, see Task G. To secure the
escutcheons and complete the connections: on
6. Reinstall the inside lever/knob. For mortise instructions,
see Task G. To reinstall the inside and outside levers/knobs: on
page 4–21. For cylindrical instructions, see Task H. To reinstall the
inside and outside levers/knobs: on
6.2.
page 4–17. For cylindrical instructions, see
page
page 5–15.
5–16.
W Series Service Manual