BEST ACCESS SYSTEMS W Series Service Manual page 147

W Series Service Manual
Additional Service and Maintenance for IDH Max Locks
5. Connect the reader wire harness to the control electronics circuit
board. For mortise instructions, see Task E. To connect the reader
wire harness: on
Tighten the RQE rose liner on the door with the through-bolts. on
page 5–12.
6. Make the connections and reinstall the inside escutcheon. For
mortise instructions, see Task F. To secure the escutcheons and
complete the connections: on
instructions, see Task G. To secure the escutcheons and complete
the connections: on
7. Reinstall the inside lever/knob. For mortise instructions,
see Task G. To reinstall the inside and outside levers/knobs: on
page 4–21. For cylindrical instructions, see Task H. To reinstall the
inside and outside levers/knobs: on
8. Reinstall the core and throw member. For mortise instructions, see
Task H. To reinstall the core (EEL and EEU only): on
For cylindrical instructions, see Task I. To reinstall the core and
throw member: on
9. Making sure that the access door does not pinch any wires, insert
the tabs of the access door into its mating slots and swing the door
closed. Use the appropriate bit driver to secure the access door with
the security screw. Tighten firmly.
page 4–17. For cylindrical instructions, see
page 4–20. For cylindrical
page 5–15.
page
page 5–17.
5–16.
page 4–23.
6–7