BEST ACCESS SYSTEMS W Series Service Manual page 176

Installation Instructions for 34HW–35HW IDH Max Mortise Locks
13
Connect reader wire harness
1 From the outside of the door, feed the reader wire
harness connector through the field harness & reader
wire hole.
2 Temporarily rest the outside trim on the door by
inserting the trim studs into the stud holes.
Note: You can temporarily install the outside knob/lever
to hold the outside trim in place. See Task 15.
3 Connect the reader wire harness to the control
electronics circuit board in the inside trim.
4 Feed the solenoid and sensor wire harness from the
control electronics circuit board, as well as the
solenoid and sensor wires from the mortise case,
through the large opening in the inside trim.
Outside of door
Figure 13a Feeding the reader wire harness connector
from the outside trim through the door
12
Installing the lock
Reader wire harness
connector
Control electronics
circuit board
Reader wire
harness connector
Field harness &
Solenoid and sensor
reader wire hole
wire harness
Inside trim
Large opening
Outside trim
Sensor wires and
solenoid wires
Figure 13b Connecting the reader wire harness to the
BEST ACCESS SYSTEMS
Indianapolis, Indiana
Caution 1: When routing the reader wire harness,
make sure the reader wire harness is not routed
across any sharp edges or over any surface that could
damage its sleeving or wire insulation.
Caution 2: When connecting the reader wire harness,
make sure:
there are no loose wire connections where the
wires are inserted into the reader wire connector
the reader wire harness connector is fully seated
in its mating connector on the control electronics
circuit board.
control electronics circuit board
Inside of door