BEST ACCESS SYSTEMS W Series Service Manual page 152

Additional Service and Maintenance for IDH Max Locks
6–12
8. Remove the magnetic stripe card reader assembly from the outside
escutcheon, sliding the reader harness through the slot in the
escutcheon.
Note: To determine the read head track position for ordering a magnetic
stripe swipe card reader, look at the back of the reader for the label that
states, "This reader was factory set to reader magstripe track no. 1 2."
The track number is circled. If there is no label, the track number is 3.
Reinstalling the magnetic stripe swipe card reader
1. Orient the magnetic stripe card reader assembly and insert the
reader harness through the slot in the outside escutcheon.
2. Position the magnetic stripe card reader assembly on the reader
gasket and install the four reader assembly mounting screws.
3. Connect the reader harness to the reader circuit board and position
the circuit board in the outside escutcheon.
4. Loosely install the two reader electronics mounting screws.
5. Position the harness clamp under the left reader electronics
mounting screw. Make sure the reader wire harness is positioned
properly under the harness clamp. Tighten the screws.
6. Peel away the protective backing from the edge of the escutcheon
gasket and slide the gasket onto the upper escutcheon post. Press
the gasket into place on the edge of the escutcheon so the reader
circuit board is covered.
7. Connect the reader wire harness to the control electronics circuit
board. For mortise instructions, see Task E. To connect the reader
wire harness: on
Tighten the RQE rose liner on the door with the through-bolts. on
page 5–12.
8. Reinstall the outside escutcheon. For mortise instructions, see
Task F. To secure the escutcheons and complete the connections:
on page 4–20. For cylindrical instructions, see Task G. To secure the
escutcheons and complete the connections: on
9. Reinstall the inside lever/knob. For mortise instructions,
see Task G. To reinstall the inside and outside levers/knobs: on
page 4–21. For cylindrical instructions, see Task H. To reinstall the
inside and outside levers/knobs: on
10. Reinstall the core and throw member. For mortise instructions, see
Task H. To reinstall the core (EEL and EEU only): on
For cylindrical instructions, see Task I. To reinstall the core and
throw member: on
11. Making sure that the access door does not pinch any wires, insert
the tabs of the access door into its mating slots and swing the door
closed. Use the appropriate bit driver to secure the access door with
the security screw. Tighten firmly.
page 4–17. For cylindrical instructions, see
page
page 5–17.
page 5–15.
5–16.
page 4–23.
W Series Service Manual