BEST ACCESS SYSTEMS W Series Service Manual page 200

Installation Instructions for 83KW/93KW–85KW/95KW IDH Max Cylindrical Locks
Outside of door
Trim hole
insert
Bushings
Hub
Hub washer
Figure 14 Installing the trim hole inserts, bushings, and
hub washers
12
Trim hole
insert
Bushing
Hub
Hub washer
Inside of door
BEST ACCESS SYSTEMS
Indianapolis, Indiana
Installing the lock & through-bolt trim
14
Install trim hole inserts, bushings, and
hub washers
1 Insert the two trim hole inserts into the upper trim
hole on each side of the door, as shown in Figure 14.
2 For LH and LHRB doors
Insert two bushings into the door status switch &
LH/LHRB reader wire hole on each side of the door, as
shown in Figure 14.
For RH and RHRB doors
Insert two bushings into the field harness & RH/RHRB
reader wire hole on each side of the door.
3 Insert a bushing into the remaining wire hole on the
inside of the door, as shown in Figure 14.
4 On each side of the door, slide a hub washer over the
chassis sleeve so it rests on the hub.
Note: You do not need to change the positions of the
DIP switches on the control electronics circuit board
located in the inside escutcheon.
By default, switches 1 through 5 are set to ON. These
switches are for possible future applications.
By default, switches 6 and 7 are set to ON for
automatic baud rate detection. This setting lets you
determine the baud rate for communication between
the lock's control electronics circuit board and the
panel interface module by setting DIP switches on the
panel interface circuit board. (See page 22.)
Switch 8 is set to OFF for locks with a swipe-type
magnetic stripe card reader, a proximity reader, or a
keypad reader; it is set to ON only for locks with an
insertion-type magnetic stripe card reader.