Kia Sorento 2001 General Information Manual page 1273

2001 > 1.8L DOHC >
REMOVAL
1. Discharge refrigeration system. (Refer to operating instructions of your refrigerant recovery/recycling
/charging station for proper procedures.)
2. Remove receiver/drier a shown in figure.
Immediately plug open fittings to keep moisture out of system
INSTALLATION
Install receiver/drier in reverse order of removal.
1) Apply clean compressor oil to O-rings before connecting fittings.
2) Do not apply compressor oil to fitting nuts.
3) When installing a new receiver/drier, add compressor oil through high-pressure pipe port of
compressor.
Compressor oil: 0.61 cu in (10 cc)
Tightening torque
Receiver/drier inlet: 43~61 lb-in (4.9~6.9 N0m, 50~70 kg-cm)
Receiver/drier outlet: 43~61 lb-in (4.9~6.9 N-m, 50~70 kg-cm)