Kia Sorento 2001 General Information Manual page 1127

1. Place new blade on wiper arm, taking care that open side of hook is facing connection point.
2. Move blade (left or right) until connection point is at opening of hook.
3. Push blade into hook until lock tab sets.
4. Lower wiper arm to windshield.
Installation
Link assembly
1. Slide link assembly into position through driver's side access hole.
2. Position pivot shafts in their holes and install mounting nut and bolts.
3. Extend link assembly fully and connect link slot to wiper motor ball joint.
4. Install wiper motor. Refer to "Windshield Wiper/ Washer System" in this section.
5. Place cowl vent in position and install screws and fasteners.
6. Install wiper arms and blades. Refer to "Windshield Wiper/Washer System" in this section.
7. Check system movement.
Adjustment
Washer nozzle
1. Spray should center on driver and passenger sides of front windshield. If off-line, adjust by slightly turning
the nozzle.
2. If clogged or restricted, use a needle or wire to clear nozzle exit.