Kia Sorento 2001 General Information Manual page 1171

Check for continuity between following
each terminal of
-LH lights and ground. Is continuity
10 present?
-LH front turn : B(B) of E-09
_LH side :B(B) of F-12,
-LH rear turn : F(B) of E-14,
Turn the turn signal switch to RH position. Perform diagnosis of RH side in the same way from step
11
9 to step 10.
Hazard function hazard does not operate.
Preliminary check:
Check an open lamp filament before proceeding with diagnosis. If bulb is damaged, check connection of the
bulb and repalce bulb. In addition, check "HAZARD(15A)" fuse. If open, check for short to ground though the
wire, replace fuse and check that all system electrical connectors mated correctly.
Step
Disconnect the hazard switch connector.
Check for voltage at terminal B(R/B) of
1
hazard switch harness connector F-02.
Is battery voltage present?
Connect the hazard switch connector and
switch the hazard to ON position.
2 Check for voltage at terminal H(BR) of the
hazard switch connector F-02.
Is battery voltage present?
Check for voltage at terminal C(BR) of
3 flasher unit connector F-01.
Is battery voltage present?
Check for voltage between terminal C(BR)
and terminal B(B) or the flasher unit
4
connector F-01.
Is battery voltage present?
Check for voltage at terminal A(P) of
5 flasher unit connector F-01.
Is battery voltage present periodically?
Check for voltage at terminal D(P) of
6 hazard switch connector F-02.
Is battery voltage present periodically?
Check for voltage at terminal L(LG/R) of
7 hazard switch connector F-03.
Is battery voltage present periodically?
Check for voltage at terminal J(LG/B) of
hazard switch connector F-03.
8
Is battery voltage present periodically?
Inspection
Check for a poor connection at the lights. If
Yes
OK, replace damaged lights.
Check for a poor connection at ground. If
No
OK, repair open in the wire "B" or replace.
Yes Go to next step
Repair open or short in the wire "R/B" or
No
replace.
Yes Go to next step
Check for a poor connection at hazard
No
switch. If OK, replace the hazard switch.
Yes Go to next step
Repair open or short in the wire "BR" or
No
replace.
Yes Go to next step
Check for a poor connection at the flasher
No unit. If OK, repair open in the wire "B" to
the flasher unit or replace.
Yes Go to next step
Check for a poor connection at the flasher
No unit connector.
If OK, replace the flasher unit.
Yes Go to next step
Repair open or short in the wire "P" or
No
replace.
Yes Go to next step
Check for a poor connection at hazard
No
switch. If OK, inspect hazard switch.
Yes Go to next step
Check for a .for a poor connection at
No hazard switch connector. If OK, inspect
hazard switch.
Action