Kia Sorento 2001 General Information Manual page 1086

7. Disconnect outside door handle rod of door lock assembly from outside door handle.
8. Disconnect lock cylinder rod of door lock assembly from door lock cylinder of door handle.
9. Remove two mounting bolts on outside door handle.
10. Remove outside door handle.
11. Remove lock cylinder from outside door handle.
Installation
Power door lock assembly
1. Install door lock assembly.
A. Position it as originally positioned through access hole.
B. Install three mounting screws.
Tightening torque : 35~52 lb-in (4~6 N-m, 40~60 kg-cm)
2. Install outside door handle.
A. Connect two control rods of door lock assembly.
B. Install two mounting nuts.
3. Install plastic door screen.
A. Fasten plastic door screen.
B. Pull out electrical harness connector from plastic door screen.
C. Pull out control rod for inside door handle from plastic door screen.
4. Install inside door handle.
A. Connect two control rods or door lock assembly.
B. Install three mounting screws.