Kia Sorento 2001 General Information Manual page 1222

Step
● Observe "IMMO" indicator.
1
● Turn the ignition switch to ON.
2 ● Turn the ignition switch to START.
● Turn the ignition switch to OFF.
● Diagnostic antenna coil connector from ICU.
3
● Turn the ignition switch to ON.
● Observe "IMMO" indicator.
4 ● Perforn limphome with original corrent PIN.
5 ● Turn the ignition switch to START.
ICU status by "IMMO indicator
Action
● Disconnect antenna coil
● connector.Turn the ignition
switch to ON.
ICU type
Part number
Part number
Label color of ICU
Antenna coil
Key knob color
Before coding
"IMMO" After
indicator coding
FOR 0K2AC 67 7R0 ONLY, MUST WAIT FOR 10 SECONDS AFTER PERFORMING "ECM CHECK" WITH KIA
POWER SCAN TOOL, BECAUSE THE RELAYOF ICU IS RETURNED IN ORIGINAL POSITION AFTER
APPROXIMATELY 10 SECONDS. IF YOU START ENGINE WITHIN 10 SECONDS, THERE ISTHE POSSIBLE OF
NOT STARTING ENGINE OR OCCURRING ECU FAULT CODE.
Before serving
Step
● Turn the ignition switch to ON.
1
● Check if "IMMO" indicator illuminates or blinks.
● Disconnect the immobilizer harness connector from the
2
ICU.
Action
Part number
0K2AC 67 7R0/7R0A
0K2AC 67 7R0B
Type
Read only type
0K2AC 67 7R0/7R0A
"IMMO" indicator illuminates for
approximately two seconds and goes
out.
"IMMO" indicator illuminates for
OK approximately two seconds and goes
out.
"IMMO" indicator blinks continuously
NO
(2Hz).
Inspection
"IMMO" indicator illuminates for approximately
two seconds and goes out.
Engine starts.
"IMMO" indicator blinks continuously (2Hz).
"IMMO" indicator blinks from 2Hz to 0.5Hz.
Engine starts.
Virgin
"IMMO" indicator illuminates for
approximately two seconds and
goes out.
"IMMO" indicator blinks at three
times for approximately one
second.
White
Common
Black
Go to step7
Go to step3
Normal results
Neutralized/Learnt
"IMMO" indicator blinks
continuously (2Hz).
Encrypt type
0K2AC 67 7R0B
Yellow
Deep bule
"IMMO" indicator blinks at three times for
approximately on second.
"IMMO" indicator illuminates for
approximately two seconds and goes
out.
"IMMO" indicator blinks continuously
(2Hz).
Yes
Go to step2
Repair or replace
No