Subaru Legacy 2005 Service Manual page 687

23.Fuel
A: PROCEDURE
1. RELEASING OF FUEL PRESSURE
WARNING:
• Place "NO FIRE" signs near the working area.
• Be careful not to spill fuel on the floor.
1) Remove the fuse of fuel pump from main fuse
box.
2) Start the engine and run until it stalls.
3) After the engine stalls, crank it for five more sec-
onds.
4) Turn the ignition switch to OFF.
2. DRAINING FUEL
WARNING:
• Place "NO FIRE" signs near the working area.
• Be careful not to spill fuel on the floor.
1) Set the vehicle on a lift.
2) Disconnect the ground cable from battery.
3) Open the fuel filler flap lid, and remove the fuel
filler cap.
4) Lift-up the vehicle.
5) Remove the fuel tank protector.
Fuel
6) Set a container under the vehicle and remove
the drain plug from fuel tank to drain fuel from fuel
tank.
7) Tighten the fuel drain plug.
NOTE:
Use a new gasket.
Tightening torque:
26 N
8) Install the fuel tank protector.
FU-01122
NOTE:
Use a new nut.
Tightening torque:
Nut
Bolt
IN-00203
FU(H4SO 2.5)-41
FUEL INJECTION (FUEL SYSTEMS)
⋅
m (2.65 kgf-m, 19.2 ft-lb)
⋅
9 N m (0.9 kgf-m, 6.6 ft-lb)
⋅
17.5 N m (1.78 kgf-m, 12.9 ft-lb)
FU-01123