Subaru Legacy 2005 Service Manual page 1126

MECHANICAL
11) Install the timing belt cover No. 2 (LH).
Tightening torque:
⋅
5 N m (0.5 kgf-m, 3.7 ft-lb)
12) Install the tensioner bracket.
Tightening torque:
⋅
24.5 N m (2.5 kgf-m, 18.1 ft-lb)
13) Install the crank sprocket.
<Ref. to ME(H4DOTC)-55, INSTALLATION, Crank
Sprocket.>
14) Install the cam sprocket.
<Ref. to ME(H4DOTC)-54, INSTALLATION, Cam
Sprocket.>
15) Install the timing belt. <Ref. to ME(H4DOTC)-
48, INSTALLATION, Timing Belt.>
16) Install the timing belt cover.
<Ref. to ME(H4DOTC)-45, INSTALLATION, Tim-
ing Belt Cover.>
17) Install the crank pulley.
<Ref. to ME(H4DOTC)-43, INSTALLATION, Crank
Pulley.>
18) Install the V-belts. <Ref. to ME(H4DOTC)-40,
INSTALLATION, V-belt.>
Camshaft
C: INSPECTION
1) Measure the bend, and repair or replace if nec-
essary.
Specification:
0.020 mm (0.0008 in) or less
ME-00106
2) Check the journal for damage and wear. Re-
place if faulty.
3) Measure the outside diameter of camshaft jour-
nal. If the journal diameter is not within specifica-
tion, check the oil clearance.
Specifica-
tion
mm (in)
4) Measurement of the camshaft journal oil clear-
ME-00105
ance:
(1) Clean the bearing caps and camshaft jour-
nals.
(2) Place the camshafts on cylinder head.
(Without installing the valve rocker.)
(3) Place a plastigauge across each of the cam-
shaft journals.
(4) Gradually tighten the cap in at least two
stages in alphabetical sequence as shown in the
figure, and then tighten to the specified torque.
Do not turn the camshaft.
Tightening torque:
T1: 9.75 N
T2: 20 N
(5) Remove the bearing caps.
ME(H4DOTC)-60
Camshaft journal
Front
37.946 — 37.963
(1.4939 — 1.4946)
⋅
m (1.0 kgf-m, 7.2 ft-lb)
⋅
m (2.0 kgf-m, 14.8 ft-lb)
T2
(A)
(E)
T1
(F)
(B)
ME-00118
Center, rear
29.946 — 29.963
(1.1790 — 1.1797)
(C)
(D)
ME-00774