Table of Contents
Advertisement
FUEL INJECTION (FUEL SYSTEMS)
16.Engine Control Module (ECM)
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the lower inner trim of passenger's
side.
<Ref. to EI-60, REMOVAL, Lower Inner Trim.>
3) Detach the floor mat of passenger's seat.
4) Remove the protect cover.
5) Remove the nuts (A) which hold ECM to bracket.
6) Remove the clip (B) from bracket.
(A)
(A)
7) Disconnect the ECM connectors, and take out
the ECM.
Engine Control Module (ECM)
IN-00203
FU-00896
(B)
FU-00897
FU(H4DOTC)-34
B: INSTALLATION
Install in the reverse order of removal.
CAUTION:
• When replacing the ECM, be careful not to
use the wrong spec. ECM to avoid any damage
to fuel injection system.
• When replacing the ECM, be careful not to
damage the harnesses and connectors.
Tightening torque:
⋅
5 N
m (0.5 kgf-m, 3.7 ft-lb)
Advertisement
Chapters
Table of Contents
