Subaru Legacy 2005 Service Manual page 415

Hide thumbs Also See for Legacy 2005:

Table of Contents

(3) Separate the brush from connection to re-

10) Remove the rectifier as follows.

(1) Remove the bolts which secure rectifier.

(2) Remove the cover of terminal B.

(3) Remove the nut of terminal B, and then re-

move the rectifier.

Assemble in the reverse order of disassembly.

1) Pulling up brush

Before assembling, press the brush down into

brush holder, and then fix them in that position by

passing a [1 mm (0.08 in) dia. 40 to 50 mm (1.6 to

2.0 in) long] wire through the hole as shown in the

Be sure to remove the wire after reassembly.

2) Install the ball bearing.

(1) Set the ball bearing on the front cover, and

then securely install an appropriate tool (such as

a fit socket wrench) to the bearing outer race.

(2) Press the ball bearing into the specified po-

sition using a press.

(3) Install the bearing retainer.

3) Press the bearing (rear side) into the rotor shaft

using a press to install.

4) Heat the bearing box in rear cover [50 to 60°C

(122 to 140°F)], and then press the rear bearing

into rear cover.

Grease should not be applied to rear bearing.

Remove the oil completely if it is found on bear-

5) After reassembly, turn the pulley by hand to

check that rotor turns smoothly.

SC(H4SO 2.0)-17

STARTING/CHARGING SYSTEMS

Chapters

Table of Contents