Subaru Legacy 2005 Service Manual page 1135

21.Cylinder Block
A: REMOVAL
NOTE:
Before conducting this procedure, drain engine oil
completely.
1) Remove the intake manifold.
<Ref. to FU(H4DOTC)-12, REMOVAL, Intake Man-
ifold.>
2) Remove the V-belts. <Ref. to ME(H4DOTC)-40,
REMOVAL, V-belt.>
3) Remove the crank pulley.
<Ref. to ME(H4DOTC)-43, REMOVAL, Crank Pul-
ley.>
4) Remove the timing belt cover.
<Ref. to ME(H4DOTC)-45, REMOVAL, Timing Belt
Cover.>
5) Remove the timing belt.
<Ref. to ME(H4DOTC)-46, REMOVAL, Timing
Belt.>
6) Remove the cam sprocket.
<Ref. to ME(H4DOTC)-54, REMOVAL, Cam
Sprocket.>
7) Remove the crank sprocket.
<Ref. to ME(H4DOTC)-55, REMOVAL, Crank
Sprocket.>
8) Remove the generator and A/C compressor with
their brackets.
9) Remove the cylinder head.
<Ref. to ME(H4DOTC)-62, REMOVAL, Cylinder
Head.>
10) Remove the clutch disc and cover. (MT model)
<Ref. to CL-16, REMOVAL, Clutch Disc and Cov-
er.>
11) Remove the flywheel. (MT model)
<Ref. to CL-16, REMOVAL, Clutch Disc and Cov-
er.>
ST 498497100 CRANKSHAFT STOPPER
Cylinder Block
ST
ME-00778
ME(H4DOTC)-69
12) Remove the drive plate. (AT model)
Use the ST to lock crankshaft.
ST 498497100 CRANKSHAFT STOPPER
13) Remove the oil separator cover.
14) Remove the water by-pass pipe for heater.
15) Remove the water pump.
16) Remove the oil filter.
17) Remove the oil cooler. (MT model)
T2
(A)
(B)
T1
(C)
(A) O-ring
(B) Oil cooler
(C) Oil cooler connector
18) Removal of oil pan:
(1) Place the #2 and #4 cylinder side upward.
(2) Remove the bolts which secure oil pan to
cylinder block.
(3) Insert a oil pan cutter blade between cylin-
der block-to-oil pan clearance and remove the
oil pan. Do not use a screwdriver or similar tools
in place of oil pan cutter.
MECHANICAL
ST
ME-00136
ME-00723