Table of Contents
Advertisement
27) Apply liquid gasket to the mating surfaces and
the threaded portion of bolt (A) shown in the figure,
and then install the oil separator cover.
NOTE:
Install them within 20 min. from applying liquid gas-
ket.
Liquid gasket:
THREE BOND 1207C (Part No. 004403012) or
equivalent
Tightening torque:
⋅
6.4 N
m (0.65 kgf-m, 4.7 ft-lb)
28) Install the drive plate. (AT model)
To lock the crankshaft, use the ST.
ST 498497100
CRANKSHAFT STOPPER
Tightening torque:
⋅
72 N
m (7.3 kgf-m, 53.1 ft-lb)
29) Install the flywheel. (MT model) <Ref. to CL-21,
INSTALLATION, Flywheel.>
30) Install the clutch disk and cover. (MT model)
<Ref. to CL-16, INSTALLATION, Clutch Disc and
Cover.>
Cylinder Block
31) Installation of oil pump
ST 499587100
NOTE:
Use a new front oil seal.
(A)
Liquid gasket:
ME-02452
ST
ME-00136
ME(H4DOTC)-79
(1) Install the front oil seal using ST.
OIL SEAL INSTALLER
(2) Apply liquid gasket to the matching surface
of oil pump.
THREE BOND 1215 (Part No. 004403007) or
equivalent
(A) O-ring
(3) Apply a coat of engine oil to the inside of oil
seal.
MECHANICAL
ME-00164
(A)
ME-00165
ME-00312
Advertisement
Chapters
Table of Contents
