Table of Contents
Advertisement
2. REAR SIDE BELT
1) Remove the A/C belt tensioner.
2) Install the V-belt, and tighten the slider bolt (B)
so as to obtain the specified belt tension.
<Ref. to ME(H4DOTC)-41, INSPECTION, V-belt.>
3) Tighten the lock nut (A).
Tightening torque:
Lock nut (A)
⋅
22.6 N
m (2.3 kgf-m, 16.6 ft-lb)
V-belt
(B)
(A)
ME-00060
ME(H4DOTC)-41
C: INSPECTION
1) Replace the belts, if crack, fraying or wear is
found.
2) Check the V-belt tension and adjust it if neces-
sary by changing the generator installing position
and idler pulley installing position.
Belt tension (with belt tension gauge):
(A)
When installing new parts
618 — 755 N (63 — 77 kgf, 139 — 170 lbf)
At inspection
490 — 640 N (50 — 65 kgf, 110 — 144 lbf)
(B)
When installing new parts
740 — 880 N (75 — 90 kgf, 166 — 198 lbf)
At inspection
350 — 450 N (36 — 46 kgf, 78 — 101 lbf)
(A)
GEN
P/S
(A) Front side belt
(B) Rear side belt
C/P Crank pulley
GEN Generator
P/S Power steering oil pump pulley
A/C A/C compressor pulley
I/P Idler pulley
MECHANICAL
A/C
(B)
I/P
C/P
PM-00154
Advertisement
Chapters
Table of Contents
