Subaru Legacy 2005 Service Manual page 1100

MECHANICAL
25) Support the transmission with a garage jack.
CAUTION:
Doing this is very important because the trans-
mission lowers for its own weight. This work is
also of great importance for facilitating reinstal-
lation.
CAUTION:
Before removing the engine away from trans-
mission, check to be sure no work has been
overlooked.
26) Separation of engine and transmission
(1) Remove the starter. <Ref. to SC(H4SO 2.0)-
6, REMOVAL, Starter.>
(2) Install the ST to converter case. (AT model)
ST 498277200 STOPPER SET
(3) Remove the bolts which hold upper side of
the transmission to engine.
27) Remove the engine from vehicle.
(1) Slightly raise the engine.
(2) Raise the transmission with garage jack.
(3) Move the engine horizontally until main
shaft is withdrawn from clutch cover.
Engine Assembly
ME-00048
ST
ME-00049
ME-00050
ME(H4DOTC)-34
(4) Slowly move the engine away from engine
compartment.
NOTE:
Be careful not to damage adjacent parts or body
panels with crank pulley, oil level gauge, etc.
28) Remove the front cushion rubbers.
B: INSTALLATION
1) Install the front cushion rubbers to engine.
Tightening torque:
⋅
35 N m (3.6 kgf-m, 25.8 ft-lb)
2) Install the engine to transmission.
(1) Position the engine in engine compartment
and align it with transmission.
NOTE:
Be careful not to damage adjacent parts or body
panels with crank pulley, oil pressure gauge, etc.
(2) Apply a small amount of grease to the spline
of main shaft. (MT model)
3) Tighten the bolts which hold upper side of trans-
mission to engine.
Tightening torque:
⋅
50 N m (5.1 kgf-m, 36.9 ft-lb)
4) Remove the lifting device and wire ropes.
5) Remove the garage jack.
ME-00050
LU-00222