Table of Contents
Advertisement
ENGINE (DIAGNOSTICS)
• Since the rear wheels will also rotate, do not
place anything near them. Also, make sure that
nobody goes in front of the vehicle.
(A) Rigid racks
(B) Free rollers
2. SUBARU SELECT MONITOR
1) After clearing the memory, check for any remain-
ing
unresolved
trouble
EN(H4DOTC)(diag)-37, Clear Memory Mode.>
2) Idle the engine.
3) Prepare the Subaru Select Monitor kit. <Ref. to
EN(H4DOTC)(diag)-7,
General Description.>
4) Connect the diagnosis cable to Subaru Select
Monitor.
Inspection Mode
(A)
(B)
EN-00041
data.
<Ref.
PREPARATION
TOOL,
EN-00038
EN(H4DOTC)(diag)-32
5) Insert the cartridge to Subaru Select Monitor.
<Ref. to EN(H4DOTC)(diag)-7, PREPARATION
TOOL, General Description.>
6) Connect the test mode connector (A) located at
the lower portion of glove box.
7) Connect the Subaru Select Monitor to data link
connector located in the lower portion of the instru-
ment panel (on the driver's side).
to
CAUTION:
Do not connect any scan tools except Subaru
Select Monitor or general scan tool.
EN-00039
(A)
EN-01983
EN-02097
Advertisement
Chapters
Table of Contents
