Subaru Legacy 2005 Service Manual page 1225

20) Remove the baffle plate.
(D)
(C)
(B)
(A)
(A) Oil pan
(B) Oil strainer
(C) Baffle plate
(D) Cylinder block
B: INSTALLATION
CAUTION:
Before installing the oil pan, wipe clean the oil
pan and the mating face of engine block.
1) Make sure that the seals (A) are installed se-
curely on the buffle plate in a direction as shown in
the figure below.
(A)
2) Install the baffle plate.
Tightening torque:
⋅
6.4 N m (0.65 kgf-m, 4.7 ft-lb)
3) Install the oil strainer onto baffle plate.
NOTE:
Use a new O-ring.
Oil Pan and Strainer
Tightening torque:
10 N
4) Apply liquid gasket to the mating surfaces, and
install the oil pan.
Liquid gasket:
THREE BOND 1207C (Part No. 004403012) or
equivalent
5) Tighten the bolt which installs oil pan to engine
block.
Tightening torque:
LU-02156 5 N
LU-00052
6) Lower the engine onto front crossmember.
7) Tighten the nuts which install front cushion rub-
ber onto front crossmember.
LU(H4DOTC)-15
⋅
m (1.0 kgf-m, 7.4 ft-lb)
⋅
m (0.5 kgf-m, 3.7 ft-lb)
(D)
(C)
(B)
(A)
(A) Oil pan
(B) Oil strainer
(C) Baffle plate
(D) Cylinder block
LUBRICATION
LU-00034
LU-02156