Subaru Legacy 2005 Service Manual page 1221

14) Remove the oil pump by using flat tip screw-
driver.
CAUTION:
Be careful not to scratch mating surfaces of
cylinder block and oil pump.
B: INSTALLATION
Install in the reverse order of removal.
Perform the following.
1) Apply liquid gasket to the mating surfaces of oil
pump.
Liquid gasket:
THREE BOND 1215 (Part No. 004403007) or
equivalent
2) Replace the O-ring (A) with a new one.
3) Apply a coat of engine oil to the inside of oil seal.
4) Position the oil pump, aligning the notched area
with the crankshaft, and push the oil pump straight.
CAUTION:
• Make sure the oil seal lip is not folded.
• Be careful not to scratch the oil seal when in-
stalling oil pump on cylinder block.
Oil Pump
LU-00016
( A )
LU-00017
ME-00312
LU(H4DOTC)-11
5) Install the oil pump.
6) Apply liquid gasket to the three bolts thread. (if to
be reused)
Liquid gasket:
THREE BOND 1215 (Part No. 004403007) or
equivalent
Tightening torque:
⋅
6.4 N m (0.65 kgf-m, 4.7 ft-lb)
T
LUBRICATION
LU-02103