Subaru Impreza 2003 Service Manual page 72

PRE-DELIVERY INSPECTION
• Press the "OPEN" button on the transmitter mo-
mentarily once and check that all doors are un-
locked, the hazard light flashes twice and the
interior light illuminates.
• Close all doors and rear gate, press the "LOCK"
button of the transmitter. Press the "OPEN" button
of the transmitter and wait for 30 seconds. Check
that all doors and the rear gate are automatically
locked again.
23.SEAT
Check that each seat provides full functionality in
sliding and reclining. Check all available functions
of the rear seat such as a trunk-through center arm
rest.
24.SEAT BELT
Pull out the seat belt and then release it. Check that
the belt webbing retracts smoothly.
25.WHEEL ALIGNMENT
Check the wheel alignments. <Ref. to FS-7, Wheel
Alignment.> and <Ref. to RS-10, Wheel Align-
ment.>
26.TEST MODE CONNECTOR
Turn the ignition switch to ON and check that the
malfunction indicator light starts blinking. If the light
blinks, return the ignition key to LOCK and discon-
nect the test mode connector. Then, turn the igni-
tion key to ON again. If the malfunction indicator
light blinks at that time in spite of the disconnected
test mode connector, carry out an engine diagno-
sis.
PRE-DELIVERY INSPECTION
PI-00109
PI-10
• With OBD MODEL
(A) Test mode connector (Green)
• Without OBD MODEL
(A) Read memory connector (Black)
(B) Test mode connector (Green)
27.STARTING CONDITION
Start the engine and check that the engine starts
smoothly. If any battery voltage problems are
found, recharge or replace the battery. If any ab-
normal noises are observed, immediately stop the
engine and check and repair the necessary compo-
nents.
28.EXHAUST SYSTEM
Listen to the exhaust noise to see if no abnormal
noises are observed.
29.INDICATOR LIGHT
Check that all the indicator lights are off.
30.CLOCK
Check the clock for normal operations and enough
accuracy.
31.RADIO
Check the radio for full functionality and normal
noise level. Also check the CD unit operations.
( A )
PI-00119
( B )
( A )
PI-00120