Subaru Impreza 2003 Service Manual page 250

MECHANICAL
18) Separate the torque converter clutch from drive
plate. (AT model)
(1) Lower the vehicle.
(2) Remove the service hole plug.
(3) Remove the bolts which hold the torque
converter clutch to drive plate.
(4) Remove other bolts while rotating the en-
gine using socket wrench.
19) Remove the pitching stopper.
20) Disconnect the fuel delivery hose (A), return
hose (B) and evaporation hose (C).
CAUTION:
• Disconnect the hose with its end wrapped
with cloth to prevent fuel from splashing.
• Catch fuel from the hose into container.
( A)
ENGINE ASSEMBLY
ME-00212
ME-00213
(B )
(C)
FU-00149
ME(H4SO)-38
21) Support the engine with a lifting device and
wire ropes.
22) Support the transmission with a garage jack.
CAUTION:
Before moving the engine away from transmis-
sion, check to be sure no work has been over-
looked. Doing this is very important in order to
facilitate re-installation and because the trans-
mission lowers under its own weight.
(A) Transmission
(B) Garage jack
23) Separation of the engine and transmission.
(1) Remove the starter. <Ref. to SC(H4SO)-7,
REMOVAL, Starter.>
(2) Remove the bolts which hold the upper side
of transmission to engine.
ME-00214
(A)
(B)
ME-00215
ME-00216