Subaru Impreza 2003 Service Manual page 66

PRE-DELIVERY INSPECTION
Step
24. Seat belt
25. Wheel alignment
Checks with the Engine Running
Step
26. Test mode connector
27. Starting condition
28. Exhaust system
29. Indicator light
30. Clock
31. Radio
32. Front accessory power supply socket
33. Lighting system
34. Window washer
35. Wiper
36. Power window operation check
Dynamic Test with the Vehicle Running
Step
37. Brake test
38. Parking brake
39. AT shift control
40. Heater & ventilation
41. Air conditioner
42. Cruise control
Checks after Dynamic Test
Step
43. ATF level
44. Power steering fluid level
45. Fluid leak check
46. Water leak check
47. Appearance check 2
PRE-DELIVERY INSPECTION
Check the seat belt installation conditions and functionality.
Check that the wheel alignments are properly adjusted.
Test mode connector.
Start the engine and check that the engine starts smoothly.
Check that the exhaust noise is normal and no leaks are found.
Check that all the indicator lights operate normally.
Check that the clock operates normally.
Check that the radio system operates normally.
Check that the front accessory power supply socket operates normally.
Check that the lighting systems operate normally.
Check that the window washer system operates normally.
Check that the wiper system operates normally.
Check the power window for correct operations.
Check that the foot brake operates normally.
Check that the parking brake operates normally.
Check the AT shift patterns are correct.
Check that the heater & ventilation system operates normally.
Check that the air conditioner operates normally.
Check that the cruise control system operates normally.
Check that the ATF level is normal.
Check that the power steering fluid level is normal.
Check for fluid/oil leaks.
Spray the vehicle with water and check for water leaks.
(1) Remove the protective coating (if any).
(2) Check the body paints for damage and smears.
(3) Check the plated parts for damage and rust.
PI-4
Check point
Check point
Check point
Check point