Subaru Impreza 2003 Service Manual page 398

STARTING/CHARGING SYSTEMS
C: DISASSEMBLY
1. STARTER ASSEMBLY
1) Loosen the nut which holds the terminal M of
switch assembly, and then disconnect the connec-
tor.
2) Remove the bolts which hold the switch assem-
bly, and then remove switch assembly, plunger and
plunger spring from starter as a unit.
NOTE:
Be careful because the pinion gap adjustment
washer may sometimes be used on the mounting
surface of switch assembly.
(B)
(A) Switch assembly
(B) Plunger
3) Remove both through-bolts and brush holder
screws, and then detach the rear cover and brush
holder.
(A) Brush holder
(B) Rear cover
(A)
SC-00169
(A)
(B)
SC-00170
STARTER
4) Remove the armature and yoke from front brack-
et. The ball used as a bearing will come off from the
armature end.
NOTE:
Before removal of the yoke, put alignment marks
on the yoke and front bracket.
(A)
(A) Front bracket
(B) Yoke
(C) Ball
(D) Armature
5) Remove packing A, planetary gears, packing B
and plate.
(C)
(D)
(A) Packing A
(B) Planetary gear
(C) Plate
(D) Packing B
SC(H4SO)-8
(B)
(D)
(C)
SC-00171
(B)
(A)
SC-00172