Subaru Impreza 2003 Service Manual page 379

ACCELERATOR CONTROL CABLE
SPEED CONTROL SYSTEMS
3. Accelerator Control Cable
A: REMOVAL
1) Remove the accelerator pedal.
<Ref. to SP(H4SO)-4, REMOVAL, Accelerator
Pedal.>
2) Separate the accelerator cable and accelerator
pedal.
B: INSTALLATION
1) Install in the reverse order of removal.
NOTE:
• If the cable clamp is damaged, replace it with a
new one.
• Never fail to cover the outer cable end with boot.
• Be careful not to kink the accelerator cable.
• Do not apply grease to except specified part.
2) Apply grease to engine side accelerator cable
end.
Grease:
Silicolube G-30M (Part No. 004404002)
( A )
( B )
SP-00042
3) Adjustment after pedal installation. <Ref. to
SP(H4SO)-7, ADJUSTMENT, Accelerator Pedal.>
C: INSPECTION
1) Make sure the inner cable is not twisted or worn.
2) Make sure the outer cable is not cracked.
SP(H4SO)-9