Subaru Impreza 2003 Service Manual page 459

COMPULSORY VALVE OPERATION CHECK MODE
15.Compulsory Valve Operation
Check Mode
A: OPERATION
1) Prepare the Subaru Select Monitor kit. <Ref. to
EN(H4SO)-8, PREPARATION TOOL, General De-
scription.>
2) Connect the diagnosis cable to Subaru Select
Monitor.
3) Insert the cartridge into Subaru Select Monitor.
<Ref. to EN(H4SO)-8, PREPARATION TOOL,
General Description.>
4) Connect the test mode connector (A) at the low-
er portion of instrument panel (on driver's side).
(A)
5) Connect the Subaru Select Monitor to data link
connector.
(1) Data link connector is located in the lower
portion of instrument panel (on driver's side).
(2) Connect the diagnosis cable to data link
connector.
EN-00038
CAUTION:
Do not connect scan tools except for Subaru
Select Monitor and OBD-II general scan tool.
6) Turn the ignition switch to ON (engine OFF) and
Subaru Select Monitor switch to ON.
EN-00039
7) On «Main Menu» display screen, select the {2.
Each System Check} and press the [YES] key.
8) On «System Selection Menu» display screen,
select the {Engine Control System} and press the
[YES] key.
9) Press the [YES] key after the information of en-
gine type is displayed.
10) On «Engine Diagnosis» display screen, select
the {System Operation Check Mode} and press the
[YES] key.
11) On «System Operation Check Mode» display
EN-01164 screen, select the {Actuator ON/OFF Operation}
and press the [YES] key.
12) Select the desired compulsory actuator on the
«Actuator ON/OFF Operation» display screen and
press the [YES] key.
EN(H4SO)-47
ENGINE (DIAGNOSTICS)
(A) Power switch
IM-00072
(A)
EN-00040