Subaru Impreza 2003 Service Manual page 405

Hide thumbs Also See for Impreza 2003:

Table of Contents

C: DISASSEMBLY

1) Remove the four through-bolts.

2) Heat portion (A) of rear cover to 50°C (122°F)

with a heater drier.

3) Then insert the tip of a flat tip screwdriver into the

gap between stator core and front cover. Pry them

apart to disassemble.

(A) Screwdriver

4) Hold the rotor with a vise and remove pulley nut.

STARTING/CHARGING SYSTEMS

When holding the rotor with a vise, place alumi-

num plates or wooden pieces on the vise jaws

to prevent rotor from damage.

(A) Front cover

5) Remove the ball bearing as follows.

(1) Remove the bolt, and then remove the bear-

ing retainer.

(2) Firmly install an appropriate tool (such as a

fit socket wrench) to bearing inner race.

(3) Push the ball bearing off the front cover us-

ing a press.

Show Quick Links

Chapters

Table of Contents