How To Connect And Run Multiple Drives - Danfoss MCO 305 Operating Instructions Manual

Hide thumbs Also See for MCO 305:

Table of Contents

MCO 305 Operating Instructions

__ How to Install the Application __

3. When copy is completed, paste the drive in-to a project folder.

4. Save the project.

Now parameters and MCO 305 data is stored in the project file, restore by the following steps:

1. Open the project file with MCT 10.

2. Go on-line with the drive via the Network folder.

3. Open the project folder, Right click on the drive folder and select "Write to drive".

Now both parameters and MCO 305 data is restored in the drive.

Backup and Restore via LCP

Both parameters and MCO 305 data can be stored in the LCP and thus restored from the LCP to another

drive.

Use the following steps to back-up parameters data in the LCP:

1. Select "All to LCP" [1] in parameter 0-50 LCP copy.

2. Select "File from MCO to LCP" [4] in parameter 0-50 LCP copy.

Now parameters and MCO 305 data is stored in the LCP, restore by the following steps:

1. Select "All from LCP" [2] in parameter 0-50 LCP copy.

2. Select "File from LCP to MCO" [5] in parameter 0-50 LCP copy.

Now both parameters and MCO 305 data is restored in the drive.

How to Connect and Run Multiple Drives

Use MCT 10 Networking or start APOSS directly by clicking on the application's icon. This stand-alone

operation mode allows APOSS to switch drives or connect to multiple drives. In stand-alone mode, all file

and parameter handling is done via APOSS. Thus the File menu also provides the functions for File

New,

Open, and

Save As. The Settings menu allows selecting the interface.

Run programs in several FC 300s

If you want to load the program into several controllers, link the program with the corresponding FC 300

and click on

Execute.

If you want to load a different program in each controller, open a different edit window for each FC 300,

then open the desired program file and connect it to the FC 300 with

Select Controller. Then start each

program, one after the other, with

Execute.

MG.33.K2.02 – VLT is a registered Danfoss trademark

Table of Contents