Safety Instructions And General Warnings; High Voltage Warning; Safety Instructions - Danfoss MCO 305 Operating Instructions Manual

MCO 305 Operating Instructions

Safety Instructions and General Warnings

These Operating Instructions can be used for the MCO 305 option board
with all FC 300 frequency converters with software version 4.0x.
The software version number can be seen from parameter 15-43.

High Voltage Warning

The voltage of the FC 300 is dangerous whenever the converter is connected to mains.
Incorrect fitting of the motor or FC 300 may cause damage to the equipment, serious injury or death.
Consequently, it is essential to comply with the instructions in this manual as well as local and national rules
and safety regulations.
At altitudes above 2 km, please contact Danfoss Drives regarding PELV.

Safety Instructions

Make sure the FC 300 is properly connected to earth.
Do not remove mains plugs or motor plugs while the FC 300 is connected to mains.
Protect users against supply voltage.
Protect the motor against overloading according to national and local regulations.
MCO 305
Operating Instructions
Software version: 4.xx
MG.33.K2.02 – VLT is a registered Danfoss trademark
7