How To Connect And Run Multiple Frequency Converters - Danfoss MCO 305 Operating Instructions Manual

How to Install the Applicat... MCO 305 Operating Instructions
5.3 How to Connect and Run Multiple
Frequency Converters
Use MCT 10 Networking or start APOSS directly by clicking
on the application's icon. This stand-alone operation mode
allows APOSS to switch frequency converters or connect to
multiple frequency converters. In stand-alone mode, all file
and parameter handling is done via APOSS. Thus the File
menu also provides the functions for File → New, → Open,
and → Save As. The Settings menu allows selecting the
5 5
interface.
Run programs in several frequency converters
If you want to load the program into several controllers,
link the program with the corresponding VLT
AutomationDrive and click on → Execute.
If you want to load a different program in each controller,
open a different edit window for each VLT
AutomationDrive, then open the desired program file and
connect it to the VLT AutomationDrive with → Select
Controller. Then start each program, one after the other,
with → Execute.
®
MG.33.K3.02 - VLT is a registered Danfoss trademark 25