Danfoss MCO 305 Operating Instructions Manual page 13

Hide thumbs Also See for MCO 305:

Table of Contents

MCO 305 Operating Instructions

__ How to Install __

Electrical Installation

All control cables must be screened and the cable screen must be connected to earth at both ends. It is

very important to use the correct cable for encoders to avoid noise problems, always follow the prescrip-

tions of the encoder supplier. See also FC 300 Design Guide (MG.33.AX.XX) for more information regarding

EMC correct cable installation.

MCO 305 Control Terminals

Frame size A2 and A3:

All MCO 305 terminals are located behind the C-

option terminal cover, see illustration.

Frame size A5, B1 and B2:

All MCO 305 terminals are located next to the

FC 300 control card. Remove the front cover to get

access, see illustration.

MG.33.K2.02 – VLT is a registered Danfoss trademark

Table of Contents