Printronix S828 Programmer's Manual page 153

Programmer Manual
Control Description
CO (C1) Set Inline Margin (SIM)
C2 (C3) Set Intercharacter Adjustment (SIA)
D0 (D1) Set Baseline Increment (SBI)
C6 (C7) Absolute Move Inline (AMI)
D2 (D3) Absolute Move Baseline (AMB)
C8 (C9) Relative Move Inline (RMI)
D4 (D5) Relative Move Baseline (RMB)
D8 (D9) Begin Line (BLN)
F0 (F1) Set Coded Font Local (SCFL)
F6 (F7) Set Text Orientation (STO)
F2 (F3) Begin Suppression (BSU)
Note: The controls shown in parenthesis are the text controls with their corresponding chain bit on.
Set Inline Margin (SIM)
2BD3 04 C0(C1)
Description: This control specifies the position of the inline margin in the (I) direction, when the printer
performs a Begin Line command. Receipt of this control does not change the current print position.
Parameters P1P2 form a two-byte value that specifies the margin in units. All values between 0 and
X'7FFF' are valid. A value of X'FFFF' causes the printer to use the value in the LPD command.
Note: Values as large as X'7FFF' are valid but might be off the page.
Set Intercharacter Adjustment (SIA)
2BD3 04 C2(C3)
or
2BD3 05 C2(C3)
Description: This control specifies additional inline adjustment between graphic characters.
Parameters P1P2 form a two byte value that specifies an additional increment or decrement in the inline
direction between text characters in units. All values between 0 and X'7FFF' are valid. A value of X'FFFF'
causes the printer to use the value in the LPD command.
Parameter P3 is a direction parameter and is optional. This parameter identifies whether the adjustment is
an increment or a decrement. If P3 has a value of 0 or X'FF', the adjustment is an increment. If P3 has a
value of 1, the adjustment is a decrement. If this parameter is missing, the default is an increment.
Set Baseline Increment (SBI)
2BD3 04 D0 (D1)
Chapter 5 IPDS Programming Information
Control
F4 (F5)
E4 (E5)
E6 (E7)
EE (EF)
DA (DB)
F8 (F9)
C4 (C5)
74 (75)
72 (73)
76 (77)
78 (79)
P1P2
P1P2
P1P2
P1P2
151
Description
End Suppression (ESU)
Draw I-Axis Rule (DIR)
Draw B-Axis Rule (DBR)
Repeat String (RPS)
Transparent Data (TRN)
No Operation (NOP)
Set Variable Space Increment (SVI)
Set Text Color (STC)
Overstrike (OVS)
Underscore (USC)
Temporary Baseline Move (TBM)
PTX‐S828
260071‐001A