Print Mode - Printronix S828 Programmer's Manual

Programmer Manual

Print Mode

DC2
Sets 10 cpi printing. (IBM)
ASCII Code
Hexadecimal Value
Decimal Value
This is a terminator code. It causes all data present in the print buffer to be printed. This command is
accepted at any position within the line. The character that follows this command is printed at 10 cpi.
DC2
Cancels compressed printing. (EPSON)
ASCII Code
Hexadecimal Value
Decimal Value
This is a terminator code. It causes all data present in the print buffer to be printed. This command is
accepted at any position within the line. The character that follows this command is printed as follows:
17 CPI . 10 CPI
20 CPI . 12 CPI
DC4
Cancels double width printing (IBM/EPSON).
ASCII Code
Hexadecimal Value
Decimal Value
This code cancels the double width printing set by SO or ESC SO code. It has no effect if the ESC W or
ESC ! command is set to double width.
ESC -
Sets or cancels underlined printing (IBM/EPSON).
ASCII Code
Hexadecimal Value
Decimal Value
Enables or disables underlined printing. See the following table:
n Underlined Printing
1 enabled
0 disabled
Chapter 1 EPSON/IBM Commands
DC2
X'12'
18
DC2
X'12'
18
DC4
X'14'
20
ESC - n
X'1B' X'2D' n
27 45 n
29
PTX‐S828
260071‐001A