Printronix S828 Programmer's Manual page 48

Programmer Manual
This sequence allows to design and then down-line load special characters not present in the character set
in use. Whenever you would like to start the DLL setting procedure, it should be better to copy the character
generator in ROM into RAM by sending the ESC = {0} {0} sequence that causes the DLL to be reset. Up to
256 characters can be defined using the DLL function.
The parameters in the command line have the following meaning:
n and m Indicate how many characters you should down-line load. n and m are calculated as follows:
{number of characters x 13}+2 = {total}
If {total} is less than {256}
If {total} is greater than {256}
id Indicates the printer model. In this case it is fixed to {20}.
Each DLL character is described using the following parameters:
p This is the decimal code of the first character of the character set in use that should be
replaced by the DLL character.
a1 This is the first attribute byte and it has the following meaning:
a2
Chapter 1 EPSON/IBM Commands
{n} = {t}
{m} = {0}
{n} = {remainder of {t} divided by 256}
{m} = {integer result of {t} divided by 256}
Bit 7: {0}
{1}
This bit is ignored if bit 0 or bit 1 is set to 1.
Bit 6 to 2 Ignored
Bit 1, 0 Character description:
{00} no 12-high expansion. The bit 7 is valid.
{01} line drawing character. The dots in row 8 are extended
{11} shading characters. The dots in row 1, 2, 3 and 4 are
This is the second attribute byte. It specifies the proportional printing information. If
you do not wish to define a proportional character, set the bit 6 – 0 to {0}. When you
use the proportional printing for a DLL character with bit 6 – 0 set to {0}, the databytes
of the character will be printed.
Bit 7:
Bit 6, 5, 4
Bit 3 to 0
indicates that the character is not a true descender.
indicates that the character is a true descender.
downward to rows 9, 10, 11 and 12. The bit 7 is
advisable to use this mode to create characters that should
replace 179 to 223 code characters.
repeated as rows 9, 10, 11 and 12. The Quality printing is
ignored. It is advisable to use this mode to create characters
that should replace 176 to 178 code characters.
Ignored
Interpreted as binary number. These bits specify the number
of leading bytes that should be ignored. This number is the
offset. Up to 7 bytes can be ignored. The counts begins with
byte 1.
Interpreted as binary number. These bits specify the number
of dots-columns that should be printed. Each character must
be followed by a blank byte that is not included in the count
of the character width. Character widths greater than 11 are
treated as 11.
46
PTX‐S828
ignored. It is
260071‐001A