Execute Order Any State - Printronix S828 Programmer's Manual

Programmer Manual
Decimal Hex
19-20 13-14 F0F1
21-32 15-20 XX...XX
33-34 21-22 0000
35-43 23-2B XX...XX
44-59 2C-3B XX...XX
If the printer is in 4224 emulation mode:
Decimal Hex
0-1 0-1
2-3 2-3
4 4
5-6 5-6
7 7
8-9 8-9
10-15 A-F
16-18 10-12 E5F0F3
19-21 13-15 C9C2D4
22-23 16-17 F0F1
24-35 18-23 XX...XX
36-37 24-25 0000
38-46 26-2E XX...XX
47-62 2F-3E XX...XX
Execute Order Any State (XOA)
Length D633
Subcommand Subcommand Data
The Execute Order Any State command identifies a set of subcommands (orders) that take effect
immediately, regardless of the current printer command state. This command is valid in any state.
Each data field contains a two byte order (subcommand), followed by a zero or more bytes of parameters
for that order. There is only one subcommand for a single XOA command.
The valid orders for the XOA command are:
Order Description
1000 Activate Printer Alarm (APA)
F200 Discard Buffered Data (DBD)
F400 Request Resource List (RRL)
F600 Exception Handling Control (EHC)
Chapter 5 IPDS Programming Information
Value Description
Plant of Manufacture
Sequence Number
Tag
EC Level
Device Specific
Value Description
003F Length
0013 Product Identifier
03 Length of this Field
0000 4224 with Page Counter Fix ID
38 Length of this Field
0001 4224 Product Identifier Parameter ID
F0F0F4F2F4F7 Device Type
Model Number
Manufacturer
Plant of Manufacture
Sequence Number
Tag
EC Level
Device Specific
Flag Correlation ID (Optional) Data
140
PTX‐S828
260071‐001A