Deactivate Font - Printronix S828 Programmer's Manual

Programmer Manual
Only positive values are valid for the data field. The format of the data field (DATA) for this command is:
Decimal Hex
0 0
1-3 1-3
4 4
5-7 5-7
8-9 8-9
Deactivate Font (DF)
Length D64F
The Deactivate Font command provides a means for the control unit to delete one or more fonts from the
printer.
End Page (EP)
Length D6BF
This command causes the printer to return to the home state from the page, page segment, or overlay
state. If the printer is in the page state, the printer completes any deferred printing for the current page
and advances the forms to the top of the next page. Zero or more bytes of data may be transmitted with
this command but are ignored.
End (END)
Length D65D
The End command is the ending control for a graphics block, image block, or bar code block state. This
command completes a series of write image, write graphics, or write bar code commands. This command
does not transmit any data. At the completion of this command, the printer leaves the block state and
returns to the page, overlay, or page segment state.
Execute Order Home State (XOH)
Length D68D
Subcommand Subcommand Data
The Execute Order Home State command identifies a set of subcommands (orders) for formatting physical
mediums of data, printing groups of physical mediums, and managing the fonts, page segments, and
overlays. This command is only valid while the printer is in the home state.
The data field contains a two byte order, called the subcommand, and a subcommand data field. There is
only one subcommand for a single XOH command. The subcommand data field contains parameters for
that order.
Chapter 5 IPDS Programming Information
Value
00
000000-007FFF
00
000000-007FFF
0000
Flag Correlation ID (Optional)
Flag Correlation ID (Optional)
Flag Correlation ID (Optional)
Flag Correlation ID (Optional)
Description
Reserved
X Displacement
Reserved
Y Displacement
Reserved
Data
Data
Data
Data
130
PTX‐S828
260071‐001A