Removing A Halogen Lamp Assembly - KitchenAid JOB AID 4317282 Technical Education

REMOVING A HALOGEN LAMP ASSEMBLY

WARNING
ELECTRICAL SHOCK HAZARD
Disconnect power before servicing the range.
Replace all panels before operating range.
Failure to do so can result in death or electri-
cal shock.
FIRE HAZARD
Shut off gas supply line valve before servic-
ing the range.
Check all gas line connections and replace
all panels before operating the range.
Failure to do so could result in explosion, fire,
or other injury.
CAUTION: When you work on the dual fuel
range, be careful when handling the sheet
metal parts. Sharp edges may be present, and
you can cut yourself if you are not careful.
1. Turn off the gas and electrical power going
to the range.
2. Remove the racks from inside the oven.
3. Remove the lens from the halogen lamp
socket by lifting the end by the mounting
screw and unsnapping it.
4. Remove the screw from the halogen lamp
assembly.
Lift Lens Here
Halogen Lamp
Assembly
Mounting Screw
5. Pull the halogen bulb out of the socket.
Socket Assembly
6. Pull the halogen socket assembly out of
the oven liner and cut the wires near the
socket terminals.
7. Cut the new halogen lamp socket wires to
the proper length.
8. Remove 3/8˝ of insulation from the cut
wires on the wire harness and the halogen
lamp socket. Splice the halogen lamp
socket wires to the harness wires, and
twist two wire nuts over the bare wire
ends.
2-13
Halogen Bulb
Cut Wires Here