Ignition Switches - KitchenAid JOB AID 4317282 Technical Education

WARNING
Electrical Shock Hazard
Disconnect the electrical supply from the
unit before servicing.
Failure to do so could result in death or
electrical shock.
TEST PROCEDURE
Refer to page 2-12 for the procedure for ser-
vicing the ignition switches.
NOTE: The ignition switches will be serviced
as a complete assembly (see below). If a switch
is defective, the complete assembly must be
replaced.
1. Disconnect power from the range.
2. Set the ohmmeter to the R x 1 scale.
3. Remove the top access panel (see page
2-4 for the steps).
4. Locate the two ignition switch connectors.
(one is connected to the spark module,
and the other is connected to the main
wire harness under the right front corner of
the range), and disconnect them.

IGNITION SWITCHES

Ignition Switch Wire
Connector At Spark Module
5.
3-11
Ignition Switch Wire Connector
At Main Wire Harness
Touch the test leads to the ignition switch
connectors. With all of the switches in the
Off position, the ohmmeter should indi-
cate and open circuit (infinite ∞). When a
switch is turned to the LITE position, the
ohmmeter should indicate a closed circuit
(0 ohms).