Removing A Sealed Burner & Ignitor - KitchenAid JOB AID 4317282 Technical Education

REMOVING A SEALED BURNER & IGNITOR
WARNING
ELECTRICAL SHOCK HAZARD
Disconnect power before servicing the range.
Replace all panels before operating range.
Failure to do so can result in death or electri-
cal shock.
FIRE HAZARD
Shut off gas supply line valve before servic-
ing the range.
Check all gas line connections and replace
all panels before operating the range.
Failure to do so could result in explosion, fire,
or other injury.
CAUTION: When you work on the dual fuel
range, be careful when handling the sheet
metal parts. Sharp edges may be present, and
you can cut yourself if you are not careful.
1. Turn off the gas and electrical power going
to the range.
2. Remove the grates and burner caps from
the cooktop.
Grate
3.
4.
5.
Burner Cap
2-2
Use a T20 torx screwdriver and remove
the two screws from each burner head,
then lift the heads off the cooktop.
Burner Head
Lift the rear of the cooktop, slide it forward,
and remove it.
Lift
Cooktop
To remove an ignitor from a sealed
burner:
a) Disconnect the ignitor wire from the
terminal.
b) Remove the screw from the ignitor
bracket.
Ignitor
Ignitor
Ignitor
Wire
Screw
Sealed
Ignitor
Burner
Lift
Sealed Burner