KitchenAid JOB AID 4317282 Technical Education page 20

7. To remove the ignition switches:
NOTE: The ignition switches must be replaced
as an assembly. They cannot be changed
individually.
a) If not already done, remove the cooktop
(see page 2-2), the top access panel
(see page 2-4), and the front panel (see
step 3 on page 2-8).
b) Remove the rubber shields from the
gas valve stems.
c) Pull the four ignition switches off the
gas valves.
Ignition Switches
d) Disconnect the ignition switch wires
from the harness connector and the
spark module terminal.
e) Remove the plastic grommet and pull
the ignition switch wire connectors
through the chassis hole.
Spark Module Wire
Harness Connector Wire
Ignition Switches
2-12
Plastic
Grommet