Removing The Front Panel, Display, Selector & Set Controls, Gas Valve, & Ignition Switches - KitchenAid JOB AID 4317282 Technical Education

REMOVING THE FRONT PANEL, DISPLAY, SELECTOR &
SET CONTROLS, GAS VALVE, & IGNITION SWITCHES
WARNING
ELECTRICAL SHOCK HAZARD
Disconnect power before servicing the range.
Replace all panels before operating range.
Failure to do so can result in death or electri-
cal shock.
FIRE HAZARD
Shut off gas supply line valve before servic-
ing the range.
Check all gas line connections and replace
all panels before operating the range.
Failure to do so could result in explosion, fire,
or other injury.
CAUTION: When you work on the dual fuel
range, be careful when handling the sheet
metal parts. Sharp edges may be present, and
you can cut yourself if you are not careful.
1. Turn off the gas and electrical power going
to the range.
2. Remove all of the knobs from the front
panel by pulling them off the control shafts.
3. To remove the front panel:
a) Remove the two center screws from
the selector and set bezel rings.
Screws
b) Open the oven door and remove the
two bottom end front panel screws.
Left Front Panel Screw
c) Slide the panel down so that the tabs
are out of their slots, and rotate it so that
you can access the pushbutton switches
on the back side.
Front Panel Tabs
d) Carefully unclip the small boards and
springs from the pushbutton switch
holders. Be careful not to overbend the
small clips or you will break them.
Pushbutton Switches
2-8
Right Front Panel Screw
Clip
Board
Pushbutton Switch
Holder
Pushbutton
Spring