Ricoh BRG-P1 Field Service Manual page 239

• Remove the rear unit of Tray 2 and remove any remaining paper.
• Re-install the rear unit of Tray 2.
• Remove the rear unit of Tray 3 and remove any remaining paper.
• Re-install the rear unit of Tray 3.
Action 2
• Remove Tray 2 and remove any jammed paper.
• Re-install the tray correctly.
• Remove Tray 3 and remove any jammed paper.
• Re-install the tray correctly.
Jam 23
Paper Feed Jam (Tray 3)
(J028/J29/
J035)
Paper Misfeed
Message
Press the Form Feed button.
Cause The paper being fed is longer than the paper size selected in the printer driver.
When paper fed from Tray 3 even though the sensor detected the leading edge
Details of the paper at the prescribed position, the paper did not leave the relay sensor
of Tray 3.
• Check the size of the paper loaded in the tray.
Action 1
• Make sure that the size of the loaded paper is the same length as the paper
On the printer operation panel menu, make sure that the correct paper size is
selected for the Tray.
• [ /Menu]> "Paper Input">[#Enter]
Action 2
• "Tray Paper Size">[#Enter]
• Select "Tray 3"> Select correct paper size.
Jam 24
2nd Registration Sensor Late Jam (Tray 3)
(J028/J29/
J035)
Paper Misfeed
Message
Press the Form Feed button.
selected in the printer driver
Error Codes
237