Ricoh BRG-P1 Field Service Manual page 207

No. Message
Cannot recover error
21 page(s) / FormFeed to print
remaining
Top Cover is open /Close Top
22
Cover
Rear Cover is open / Close
Rear Cover
24
(J027 only)
Cannot use High Temp./
25
Power Off On
Cannot use Low Temp./Power
26
Off On
Ink depleted / Used Ink
27
Crtrdge
Used Ink Collect Unit is set/
28
Replace Ink Collector Unit
Reset Bypass Tray correctly
29
(J028/J029/J035)
Load Paper:Tray 1
--or--
Load Paper:Tray #/ or Form
30 Feed
--or--
Load Ppr.:Bypass / or Form
Feed
An unprinted page still remains after recovery from a paper
jam or another problem and re-starting printing. Press [Form
Feed] to eject the sheet. Press [Job Reset] to delete any data
remaining from the previous job.
The top cover is open. Check and close the top cover.
The rear cover is open. Check and close the rear cover.
Machine temperature is high and has exceeded the high
temperature range for normal operation. Re-locate the
machine to a location within the temperature range and wait
for the machine to acquire room temperature.
Machine temperature is low and has fallen below the low
temperature range for normal operation. Re-locate the
machine to a location within the temperature range and wait
for the machine to acquire room temperature.
A used print cartridge has been installed. Install a new print
cartridge.
A used ink collector unit has been installed. Install a new ink
collector unit.
Multi bypass tray unit is not set correctly. Make sure that the
multi bypass tray is set correctly.
Paper has run out in the selected tray. Load paper in the
selected tray. Or, press [Form Feed] and select another tray
holding paper for printing. Press [Job Reset] to delete any
data remaining from the previous job. The tray numbers
depend on the machine model.
• For J028/J029/J035, the trays are designated Tray
1, 2, 3 or Bypass.
• For J027, the tray is designated Tray 1 only.
Troubleshooting Guide
Action
205