Invacare® Storm⁴ Series
5. Loosen screw A to remove washer B and headlight
with holder.
6. Loosen screw C to remove washer D and holder E
with lamp bracket F.
7. Take care of slot nut G inside rail.
8. Loosen nuts I to remove washers H and holder E
from lamp bracket F.
9. Replace holder.
Installing Headlight Holder
1. Install parts in reverse order.
2. Install cables carefully and secure them with cable
clamps and tie wraps.
3. Tighten screws finger-tight.
4. Adjust headlight roughly using ratchet plate as a guide.
The user can carry out final adjustment following user
manual.
5. Test all functions.
6.11.10 Replacing Rear Bulb (Conventional)
•
Size 2 Phillips screwdriver
1. Loosen and remove Phillips screw (1).
2. Remove glass.
3. Replace defective bulb.
4. Replace glass and tighten Phillips screw.
It is not intended for an individual LED to be replaced. Replace the entire lighting unit as described in 6.11.13
Replacing Complete Rear Light (LED), page 86.
84
Fig. 6-101
Fig. 6-102
Fig. 6-103
Fig. 6-104
1533060-N