Table of Contents
Advertisement
Invacare® Storm⁴ Series
Removing Headlight
1. Remove rear and centre shroud. See 6.8.1 Replacing
Rear Shroud, page 55 and 6.8.2 Replacing Centre
Shroud, page 55.
2. Take exact note of positions of all cables and sockets
that cables are connected to. Mark connectors and
sockets or take a photograph.
3. Open cable clamps (1), remove all tie wraps and pull
cable out of mobility device.
4. Disconnect cable of affected headlight from light board
(2).
5. Loosen screw A to remove washer B and headlight
from holder.
6. Replace headlight.
Installing Headlights
1. Install parts in reverse order.
2. Install cables carefully and secure them with cable
clamps and tie wraps.
3. Tighten screws finger-tight.
4. Adjust headlight roughly using ratchet plate as a guide.
The user can carry out final adjustment following user
manual.
5. Test all functions.
6.11.6 Replacing Headlight Holder (Conventional)
•
Size 2 Phillips screwdriver
•
8 mm wrench
•
Oblique pliers
•
Tie wraps
80
Fig. 6-90
Fig. 6-91
1533060-N
Advertisement
Table of Contents
