Invacare Storm 4 Series Service Manual page 35

3. Position rim-half in tyre. The holes for screws in
rim-half and ones in rotor casing need to be aligned
with each other. It can be helpful to align the notch
in rim-half and one in rotor casing where valve would
usually be, using them as a positioning guide.
4. Insert five M8 x 20 mm screws and washers at
positions (1), (2), (3), (4) and (5) and tighten them
hand-tight gradually by hand according to scheme.
5. Tighten all screws to 25 Nm according to scheme.
Calibrating True Track Plus Motor
The following section explains the calibration process with a handheld programming device.
WARNING!
Risk of accidents
Risks to workers, surroundings and mobility device.
– Do not leave mobility device unattended during following procedure.
– Make sure that both drive wheels are raised and can not touch ground.
– Secure area.
• Dynamic DX HHP" handheld programming device
1. Prop up mobility device with wooden blocks. Drive wheels must not be touching floor or work surface.
2. Connect programming device.
The programming device shows the following
DX HHp V1.20 Select a language... GB D NL S
View or edit System? YES ? DIAG TECH
Technician mode Enter Password 000 EXIT D1
D2 D3
Technician mode Master JS Module JOYSTICK
CALIBRATION EXIT YES NEXT
** MAIN MENU ** View or edit GB Power
Module ? NEXT YES
GB Controller Torque XX % EXIT NEXT DOWN
UP
GB Controller Tremor Damping XX % EXIT NEXT
DOWN UP
GB Controller Speed Progression XX % EXIT
NEXT DOWN UP
GB Controller Turn Progression XX % EXIT NEXT
DOWN UP
GB Controller Calibrate Motors? EXIT NEXT YES "YES"
GB MOTOR CALIBRATION Wheels will move!
Drive wheels raised? EXIT YES
1533060-N
You should enter this
"GB"
"TECH"
Enter code "592" with keys D1 to D3, then select "EXIT".
"NEXT"
"YES"
"NEXT"
"NEXT"
"NEXT"
"NEXT"
"YES" (if drive wheels have been raised)
Fig. 6-19
Fig. 6-20
Service
35