Table of Contents
Advertisement
Invacare® Storm⁴ Series
5. Loosen screw A to remove washer B and headlight
with holder.
6. Take care of slot nut C inside rail.
7. Loosen both screws D to remove headlight from
holder E.
8. Loosen both nuts H to remove washers G and lamp
bracket F from holder E.
9. Replace holder.
Installing Headlight Holder
1. Install parts in reverse order.
2. Install cables carefully and secure them with cable
clamps and tie wraps.
3. Tighten screws finger-tight.
4. Adjust headlight roughly using ratchet plate as a guide.
The user can carry out final adjustment following user
manual.
5. Test all functions.
6.11.8 Replacing Headlight Holder (LED)
•
4 mm Allen key
•
8 mm wrench
•
Oblique pliers
•
Tie wraps
82
Fig. 6-95
Fig. 6-96
Fig. 6-97
1533060-N
Advertisement
Table of Contents
